ChampCar Tech Desk Home

2019-11-28 18:18:45 - Porting engines and heads

Updated 6/7/2019 Jay Mauney - Chief Tech Director

Rule x.x.x. Hand Tools Mods / Tech interpretation and enforcement is that any work done to an engine with a grinder, Dremel or file is open and no points. Examples include gasket matching intake and exhaust ports, deburring intake runners or knife edging throttle body blades. This does not allow CNC porting or extrude honing.

© 2009-2020 ChumpCar International Inc., All rights reserved.
ChampCar Endurance Series ® is a Registered Trademark of ChumpCar International Inc.. ChampCar, CCES, and ChampCar.Live,
are trademarks and /or service marks of ChumpCar International Inc..
The ChampCar Endurance Series Logo and the ChumpCar Logo is a service mark of ChumpCar International Inc. and is fully protected.